Magnetized Pastilles

Here is a small project that will only take few minutes to realize with children.

Material

Transparent glass pastilles

Pictures from magazines, photos or drawings

Crafting glue (Mod Podge type) and brush

Magnets

Glue stick (Silicone or Epoxy)

Steps

Trace the shape of the pastille on the picture

Cut out the picture 3mm (1/8") smaller than the outline

Apply the crafting glue on the flat surface of the pastille

Deposit the face of the picture on the crafting glue and press to avoid air bubbles

Let dry for approximately 5 minutes

Apply a first layer of crafting glue to the endorsement of the picture

Apply a second layer of crafting glue when the first one is dry

Stick the magnet with the stick glue to the endorsement of the picture when both the layers of crafting glue are dry.

Let dry for 30 minutes

You can now use your magnetized pastille on your refrigerator door or on a memos panel.

Candle holder in mosaic

Here is a project that you may realize in few hours.

Your drawing may have a precise shape (e.g. flower, butterfly), or structured lines. You may also stick pieces randomly.

Material

Safety glasses

Glass pieces and/or glass pastilles

"Wheels" glass cutter

Triolyse Glue

Transparent glass (round or square shape for the candle holder)

Premixed ceramic grout

Grout trowel

Sponge

Candle (lantern or tea)

Steps

Draw a pattern on a sheet and stick it inside the glass with masking tape, except if you choose to stick pieces randomly.

Prepare glass pieces by cutting them with the wheels glass cutter. Always wear safety glasses.

To cut, place a glass piece between the wheels and press. The piece will break under the pressure.

Stick the glass pieces by following the pattern. The easiest way is to begin with the main subject.

Stick the glass pieces with Triolyse Glue. This one works in two stages. First, apply the activator to the candle holder, and then apply one drop on the glass piece and stick. The glue is settled within 15 seconds.

Apply the grout with the trowel.

Wait 5 to 10 minutes.

Wash the exceeding grout using a wet sponge (do not put too much water).

Clean the white film the next day when the grout is well dried.

Deposit the candle and light!

Good Do-It-Yourself!